Table of Contents
Advertisement
Citigo 2012 ➤, Citigo-e iV 2020 ➤, Enyaq 2021 ➤, Enyaq Coupe 2021 ➤, Fabia 2000 ...
– After five minutes, measure the charging current of the bat‐
tery.
Test results
If the current draw in A is 10% greater than the rated capacity
of the battery (e.g.,> 6.1A for a 61 Ah battery), then charge the
battery and retest.
– Charge the battery when the charging current is higher than
10% of the rated capacity.
– After two hours of rest for the battery, carry out a battery
check
⇒ b2.5.2 attery test with the battery tester with printer‐
VAS 6161", page 13
If the charging current is less than 10% of nominal capacity in
amperes five minutes after the charging process has started,
(e.g. for a 50 Ah battery <5A) replace the battery. In the event
of warranty and goodwill, fill out the battery test sheet.
2.8
No-load voltage measurement - Dem‐
onstration vehicles and stock vehicles
Special tools and workshop equipment required
♦ Hand multimeter (e.g. -V.A.G 1526E -)
Note
No-load voltage measurement on demonstration and stock
♦
vehicles must only be carried out within the prescribed main‐
tenance procedures as a criterion for evaluating the battery
state.
The no-load voltage measurement serves to determine
♦
whether the batteries of demonstration and stock vehicles
should be charged.
The battery must not be drained by any electrical equipment
♦
for at least 2 hours before the measurement is taken.
If the battery tester with printer -VAS 6161- is used for the
♦
measurement, the result from this tester is the determining
factor for assessment of the battery state.
Follow the procedure described below for measuring the battery
voltage in the no-load state:
– Use the hand-held multimeter to measure the battery volt‐
age.
The battery no-load voltage must not fall below 12.5 V.
If the hand-held multimeter indicates 12.5 V or more, the battery
voltage is O.K.
If the hand-held multimeter a battery voltage of less than 12.5
V:
– Charge battery
⇒ b3.1 attery", page 20
After charging wait at least 2 hours during which the battery
with electrical components must not be subjected to any load or
charge:
– Use the hand-held multimeter to measure the battery volt‐
age.
The battery no-load voltage must not fall below 12.5 V.
Electrical System - general notes - Edition 12.2021
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
19
2. Checking battery
Advertisement
Table of Contents
