Grizzly G0604Z Owner's Manual page 47

Rotate motor pulley so that you can access
4.
cutterhead body with straightedge between
insert rows (see Figure 52).
Place straightedge on outfeed table so it hangs
5.
over cutterhead, then lower outfeed table
until straightedge just touches cutterhead
body (see Figure 52).
Straightedge
Outfeed Table
Figure 52. Adjusting outfeed table even with
cutterhead body.
Place straightedge in positions shown in
6.
Figure 53. In each position, straightedge
should touch cutterhead and sit flat on outfeed
table.
Black Lines Represent
Straightedge Positions
From Overhead View
Figure 53. Straightedge positions for verifying if
outfeed table is parallel with cutterhead.
— If straightedge touches cutterhead body
and sits flat across outfeed table in each
position, then outfeed table is already
parallel with cutterhead. Follow Checking
Infeed Table instructions on this page.
— If straightedge does not touch cutterhead
and sit flat on outfeed table in any of the
positions, then outfeed table is not parallel
with cutterhead. Perform Adjusting Table
Parallelism procedure on Page 46.
Model G0604Z (Mfd. Since 02/24)
Checking Infeed Table
Follow all steps in Checking Outfeed Table
1.
on Page 44 to first make sure that outfeed
table is parallel with cutterhead.
Set outfeed table height (see Setting Outfeed
2.
Table Height on Page 48).
Rotate cutterhead so inserts will not inter-
3.
fere, then place straightedge across infeed/
outfeed tables and adjust infeed table even
with outfeed table (see Figure 54).
Straightedge
Outfeed
Figure 54. Infeed and outfeed tables set evenly.
Place straightedge in positions shown in
4.
Figure 55. In each position, the straightedge
should sit flat against both outfeed table and
infeed table.
Black Lines Represent Straightedge
Positions from Overhead View
Figure 55. Straightedge positions for checking
infeed/outfeed table parallelism.
— If straightedge sits flat against both infeed
and outfeed tables, then tables are paral-
lel. Install cutterhead guard, fence, and
rear cabinet panel.
— If straightedge does not sit flat against
both infeed and outfeed tables in any of
positions, proceed to Adjusting Table
Parallelism on Page 46.
Infeed
-45-