Table of Contents
Advertisement
Attach rabbeting table to infeed table using
6.
(2) M6-1 x 20 cap screws and 6mm flat wash-
ers pre-installed on front of infeed table (see
Figure 18).
Note: Do not fully tighten cap screws at this
time.
Figure 18. Example of installing rabbeting table.
Use a straightedge to adjust rabbeting table
7.
flush with infeed table, then fully tighten cap
screws installed in Step 6.
Set fence to 90º and move it all the way back.
8.
Insert cutterhead guard shaft into table base
9.
(see Figure 19) so shaft flat is facing set
screw, then tighten set screw against shaft.
Figure 19. Installing cutterhead guard.
Model G0604Z (Mfd. Since 02/24)
The cutterhead guard is a critical safety
feature of this jointer. You MUST verify its
operation before using the jointer! Failure
to properly install this guard will greatly
increase risk of serious personal injury.
10. Verify proper operation of cutterhead guard
by pulling cutterhead guard back and letting
it go. It should spring back over cutterhead
and contact fence without dragging across
outfeed table.
— If cutterhead guard DOES NOT spring
back over cutterhead and contact fence,
or if it drags across outfeed table, then
it must be adjusted (see Checking/
Adjusting Cutterhead Guard on Page
39 for complete instructions).
11. Install rear cabinet panel.
-21-
Advertisement
Table of Contents
