Table of Contents
Advertisement
Built-in Auto Light
INTA
ATINA
A Before you begin...
To improve recording indoors or outdoors in
* Connect the Palmcorder to a power source.
dim lighting conditions.
* Set the POWER switch to CAMERA.
Set the LIGHT switch to AUTO.
The built-in light automatically turns on and
off depending on lighting conditions.
Or set the LIGHT switch to ON/OFF to
turn the light on and off manually.
G)
D
zi
3
to
o
np
y
+
|
o.
=P will appear in the EVF while the light is
turned on.
Caution:
This light becomes hot during operation.
Make sure nothing covers the Light during
operation.
Replacing the Bulb
Before you begin...
r
NOM
c.
* Set the POWER switch to OFF.
=
^ OS
E
1 Turn screw counterclockwise and
remove.
2 (& Slide the Built-in Light unit to the
right to unlock ® and remove it.
J Turn the Bulb Housing counterclock-
ssp
wise 1/4 of a turn and pull free from
i
the Built-in Light unit.
Built-in Light Unit
Bulb Housing
+
ES
Avsing a clean cloth or tissue, replace
the buib.
5o Replace the Bulb Housing by
turning it clockwise. (8) Next, insert the
Built-in Light unit and slide it to the left
to lock it in place.
© Finally, replace
the screw.
D AN G ER .
Note:
R
* Using the light reduces battery operating time.
When replacing the bulb, use only lamp bulbs | . if using the Built-in Light in a hot environment
(PART NO. VLLW0007) supplied by
for an extended period of time, be sure to
Panasonic
to reduce
the risk of fire.
provide ventilation.
Use a cloth or tissue when handling the bulb
as finger oils will decrease the bulb life.
To, prevent possible burn hazard, disconnect
the Built-in Light and allow the lamp to cool
before replacing.
* Using the Built-in Light when the Palmcorder is
powered by a car battery may shorten bulb life.
* Be sure LIGHT switch is set to OFF when not
in use or before placing Palmcorder into an
optional carrying case.
19
Advertisement
Table of Contents
