Built-In Auto Light.19 - Panasonic Palmcorder PV-D407 Operating Instructions Manual

Built-in Auto Light
Using the Built-in Auto Light
To improve recording indoors or outdoors in
dim lighting conditions.
Before you begin...
• Connect the Palmcorder to a power source.
< Set the POWER switch to CAMERA.
Set the LIGHT switch to AUTO.
The built-in light automatically turns on and
off depending on lighting conditions.
Or set the LIGHT switch to ON/OFF to
turn the light on and off manually.
SB will appear in the EVF while the light is
turned on.
Caution:
This light becomes hot during operation.
Make sure nothing covers the Light during
operation.
Replacing the Bulb
f DANGER:
When replacing the bulb, use only lamp bulbs
(PART NO. VLLW0007) supplied by
Panasonic to reduce the risk of fire.
Use a cloth or tissue when handling the bulb
as finger oils will decrease the bulb life.
To prevent possible burn hazard, disconnect
the Built-in Light and allow the lamp to cool
^ before replacing.
Before you begin...
• Set the POWER switch to OFF.
1
Turn screw counterclockwise and
remove.
2
3
®
Slide the Built-in Light unit to the
right to unlock (§} and remove it.
Turn the Bulb Housing counterclock¬
wise 1/4 of a turn and pull free from
the Buiit-in Light unit.
'Using a clean cloth or tissue, replace
the bulb.
o
® Replace the Bulb Housing by
turning it clockwise. (S) Next, insert the
Built-in Light unit and slide it to the left
to lock it in place. © Finally, replace
the screw.
Note:
• Using the light reduces battery operating time.
• If using the Built-in Light in a hot environment
for an extended period of time, be sure to
provide ventilation.
• Using the Built-in Light when the Palmcorder is
powered by a car battery may shorten bulb life.
• Be sure LIGHT switch is set to OFF when not
in use or before placing Palmcorder into an
optional carrying case.
19