Table of Contents
Advertisement
Supplying Power
AC Adaptor
Q)
D
zi
3
à
Q)
mpr
e
pa
D
Q.
DC Power Cable
DC IN
1 Connect VCR DC OUT on the
Connector
AC Adaptor to DC IN on the
Palmcorder with the DC Power
Cable (supplied).
POWER Lamp
VCR DC OUT Connector
e
* The POWER Lamp will light.
Notes:
* AC Adaptor cannot be used to power the Palmcorder while charging the Battery.
* While not in use, unplug the AC Adaptor from the AC outlet. (When plugged into an AC outlet, the
AC Adaptor consumes 1.2W of electric power when not in use.)
Car Battery Cord (Optional)
Connect a PV-C16 Car Battery Cord
(optional) to DC IN on the Palmcorder.
x)
2 First, start your car engine, and then
DC IN
`
insert the Car Battery Cord plug into
Connector
A
,
your cigarette lighter socket.
* A fuse is located in the lighter plug end of
the cord.
Should fuse replacement be necessary
Cigarette Lighter
use the exact current rating (in amps).
Socket
(12V
Notes:
at
(12V)
* This cord can only be used in vehicles
equipped with DC 12V (negative ground)
batteries. Use only the specified car battery
cord. If you are not sure, check with your local
car/truck dealer.
* To avoid blowing the fuse, be sure to start your
car engine before inserting the cigarette lighter
Car Battery Cord
Cigarette
plug of the Car Battery Cord into the lighter
:
t
socket.
optional)
Lighter Plug
* Because the car is running while your
Palmcorder is in operation, make sure
you're in a well ventilated area.
* Disconnect the cigarette lighter plug when
your Palmcorder is not being used.
Advertisement
Table of Contents
