Table of Contents
Advertisement
Play Back your Recordings
TV Playback or Viewing
Your Patmcorder may be connected to a
Before you begin...
TV to play back tapes or to view what you
* Connect the Palmcorder to a power source.
are recording.
1 Set the POWER switch to VCR for
TV with AUDIO/VIDEO !N Jacks.
tape playback.
Or, set to CAMERA to view what your
Back of TV
Palmcorder is recording.
2 Turn the TV ON and set it to LINE
INPUT.
Check your TV operating instructions.
Note:
If your TV has no VIDEO or AUDIO IN jacks,
select CH 3 or 4 on your TV to match the
To Audio In | Y
Audio/Video
CH 3/4 switch setting on the OPTIONAL
Cable
PV-RF16 RF Adaptor. Set the VCR/TV
(Supplied)
selector on the RF Adaptor to VCR for
CY
playback.
To Audio/Video Out
3 Start playback or begin a recording.
TV without AUDIO/VIDEO IN Jacks.
If you have connected the
Palmcorder to your TV using the
PV-RF16 RF Adaptor and want to
watch TV only:
Set the POWER switch to OFF on the
Palmcorder.
VHF Antenna
Then, set the VCR/TV Selector on the RF
Adaptor to TV.
300 ohm-75 ohm
Now, turn the TV ON and select a
transformer
channel.
(not supplied)
or F Connector
UHF Antenna
To Audio/
Video Out
RF Adaptor
(optional)
CATV System Installer
This reminder is provided to call the CATV
system installer's attention to Article 820-40
Selector
of the NEC in USA (and to the Canadian
Electrical Code in Canada) that provides
D
TE
guidelines for proper grounding and, in
(not supplied)
particular, specifies that the cable ground
shall be connected to the grounding system
To VHF Antenna
of the building, as close to the point of cable
Termina!
entry as practical.
26
Advertisement
Table of Contents
