Smeg SO6606WAPNR Manual page 43

5. Touch the COOKING DURATION
button or the relevant value.
The duration of the Proving function can
be from a minimum of 1 minute to a
maximum of 12 hours and 59 minutes.
6. Scroll through the values and select the
required duration.
7. Touch the TEMPERATURE
relevant value.
8. Scroll through the values and select the
required cooking temperature (from 25°C
to 40°C).
9. Touch the CONFIRM
the settings.
10. Touch the START
Proving cycle.
When finished, a buzzer sounds briefly, which
can be deactivated by touching any point of the
display or by opening the door.
PLATE WARMING
Function that heats and keeps plates
warm. Position a baking tray on the
lowest shelf and put the plates on it to
warm.
1. Position the tray on the first shelf and place
the plates to be warmed at the centre of it.
Do not stack plates too high. Stack
plates a maximum of 5/6 high.
112 - USE
button or the
button to confirm
button to start the
2. Select
PLATE WARMING
3. Touch the START
Plate warming function.
Unless otherwise set, the Plate warming
function has a maximum duration of 12
hours and 59 minutes.
The following can be set while the function is in
operation:
• the temperature
• the duration of the function
• one programmed function
duration different from the default one is set).
When finished, a buzzer sounds briefly, which
can be deactivated by touching any point of the
display or by opening the door.
STEAM HEAT
The function steam-heats food that has
already been cooked and stored in the
fridge.
1. Place the food to be heated in a container.
2. Open the door.
3. Place the container on the rack in the
second shelf from the bottom.
4. Close the door.
5. Select
STEAM HEAT
6. Touch the COOKING DURATION
button or the relevant value.
7. Scroll through the values and select the
required cooking duration.
8. Touch the START
reservoir filling procedure.
The temperature of the steam heating
cannot be changed by the user.
9. Proceed with reservoir filling as described
above.
10. Touch the START
steam heat function.
End of steam heat
At the end, "Function ended" displays and a
buzzer sounds briefly, which can be
.
button to start the
(from 40°C to 80°C);
;
(only if a
.
button to start the
button to start the
914779546/D