Hardware Uncrating; Setup Procedure - Lincoln Electric 12926 Operator's Manual

VRTEX 360, 360+, TRANSPORT, TRANSPORT+
®

HARDWARE UNCRATING

1. Using a utility knife, carefully remove the two plastic bands
securing the carton to the skid. See Figure 17.
2. Carefully lift the carton off of the machine.
Figure 17 – Plastic band and carton
CARTON
3. Using a utility knife, carefully remove the plastic bands securing
the machine to the skid.
4. Unlock the front caster brakes.
5. Using two people, carefully lift and roll the machine off of the skid
and place in the desired work space.
6. Using a utility knife, carefully remove the two plastic bands
securing the shipping crate to the skid. See Figure 18.
7. Carefully lift the lid off of the shipping crate.
Figure 18 – Plastic band and lid removal
LID
SHIPPING
CRATE
8. Remove all components from the shipping crate.
9. Place all items into desired work space to begin setup procedure.
1. Carefully position the stand base assembly in the desired work
PLASTIC
BANDS
2. Position the two weight assemblies into the stand base. See
3. Attach the center screw to secure each weight assembly to the
NOTE: The two weight assemblies must be installed before continuing
4. Using a 3/16" allen key, remove the two long screws from the
PLASTIC
BANDS
5. Carefully insert the lower pole section into the stand base. The
6. Using a 3/16" allen key, attach the two previously removed screws
15

SETUP PROCEDURE

space. See Figure 19.
Figure 19 – Stand base
Figure 20.
stand base. See Figure 20.
with the setup procedure.
Figure 20 – Weight assemblies
CENTER
SCREWS
stand base. Retain screws, nut and washer. See Figure 21.
Note nut and washer placement for reassembly.
lower pole section is keyed and will only fit properly when installed
accordingly. See Figure 21.
securing the lower pole section to the stand base. See Figure 21.
INSTALLATION
STAND
BASE