Table of Contents
Advertisement
®
POWER MIG
360MP
INSTALLATION
Read entire installation section before starting
installation.
Safety Precautions
WARNING
ELECTRIC SHOCK can kill.
•
Do not touch electrically live parts or
electrode with skin or wet clothing.
•
Insulate yourself from work and ground.
•
Always wear dry insulating gloves.
•
Do not use AC welder if your clothing,
cloves or work area is damp or if working
on, under or inside work piece.
Use the following equipment:
- Semiautomatic DC constant voltage (wire) welder.
- DC manual (stick) welder.
- AC welder with reduced voltage control.
•
Do not operate with panels removed.
•
Disconnect input power before servicing.
FUMES AND GASES can be danger-
ous.
•
Keep your head out of fumes.
•
Use ventilation or exhaust to remove
fumes from breathing zone and general
area.
WELDING SPARKS can cause fire or
explosion.
•
Keep flammable material away.
•
Do not weld on closed containers.
ARC RAYS can burn eyes and skin.
•
Wear eye, ear and body protection.
Observe all safety information throughout this manual.
UNCRATING THE POWER MIG
Cut banding and lift off cardboard carton. Cut banding holding the
machine to the skid. Remove foam and corrugated packing
material. Untape accessories from Gas Bottle Platform. Unscrew
the two wood screws (at the Gas Bottle Platform) holding the
machine to the skid. Securely lift and remove the machine from the
skid.
LOCATION
Locate the welder in a dry location where there is free circulation
of clean air into the louvers in the back and the louvers out the
front. A location that minimizes the amount of smoke and dirt
drawn into the rear louvers reduces the chance of dirt
accumulation that can block air passages and cause overheating.
TILTING
Each machine must be placed on a secure, level surface, either
directly or on a recommended cart. The machine may topple over
if this precaution is not followed.
A-2
INSTALLATION
®
360MP
Hide quick links:
Advertisement
Table of Contents
