Table of Contents
Advertisement
Fue l consumption is reca lculated at interva ls
of 33 yards (30 meters). When the vehicle is
stationary, the most recent fue l consumption
is displayed .
Average speed
The average speed in mph (km/h) since the
last time the disp lay was reset appears in the
display .
Elapsed time
The length of time that you have been driving
since you last reset the memory appears in
this display.
Distance
The distance that has been covered since the
last time the memory was cleared appears in
the disp lay.
(D
Tips
- Fuel consumptions (ave rage and cur-
rent), range and speed are displayed in
metric units on Canadian models.
-All stored values will be lost if the veh i-
cle battery is disconnected .
Memories
The trip computer is equipped with two fully
automatic memories as well as an efficiency
program".
Fig. 17
Trip computer display: memo ry level 1
You can switch between the trip computer 1
and 2 and the efficiency program* by pressing
the
! RESET
I
button @ ¢
page 25, fig. 18.
You can tell which memo ry level is cur rently
active by the number or the sign in the display
Driver
information
display
25
¢
fig. 17.
The data from the single-trip mem-
ory (memory level 1) is being displayed if a
D
appears in the display . If a
fJ
is shown, then
the data from the total-trip memory is being
displayed (memory level 2). The fuel pump
nozzle
iii
indicates the efficiency program*
¢ page 26.
Single-trip memory (Trip computer 1)
The single-trip memory stores the trip infor-
mation from the time the ignition is turned on
until it is turned off. If the trip is continued
within 2 hours
from the time the ignition was
turned off, the new data will be included in
the calculat ion of the current trip informa-
tion. If the trip is interrupted for
more than 2
hours
the memory is reset automatically.
Total-trip memory (Trip computer 2)
Unlike the single -trip memory, the total -trip
memory is not reset automat ical ly. This per-
mits you to evaluate yo ur driving data for the
entire period between manua l resets.
Efficiency program*
The efficiency program can help you to use
less fuel ¢
page 26.
Operation
The trip computer is controlled by two
switches on the windshield wiper lever.
Fig. 18
Windsh ield wiper lever : contro ls for the trip
computer
.. To display the trip computer memory levels,
press the
I
RESET !
button ® ¢
fig. 18
re-
peatedly until the desired memory level is
shown in the display .
.,.
Advertisement
Table of Contents
