Table of Contents
Advertisement
Reprogramming the buttons
"' Switch on the ignition (do not start the en-
gine).
"'To reprogram an individual button, press
and hold the button until the LED@ starts
to flash quickly (after about ten seconds).
Release t he button immediately. The Home-
Link module will now remain in learning
mode for 5 minutes.
"'Continue with step 5.
@
Tips
- The required distance between the hand
transmitter
and the Homelink module in
the bumper ¢ fig. 192 depends on the
system that you are programming .
- Depending on the model of the garage
door opener, you may need to release the
button on the remote and press it again
when programming. When program-
ming a new device, keep the button
pressed for at least 15 seconds before
trying again with the transmitter
in a dif-
ferent position. Watch out for the emer-
gency flasher during that time.
Programming the rolling code
App lies to vehicles: with Home link
Additionally, a rolling code programming for
the Homelink universal remo te control is re-
quired for some systems.
Identifying the rolling code
"'Press the previously programmed Homelink
button again and hold it down .
"' Look at the LED@ ¢ page 161, fig. 191 . If
the LED blinks quickly, the features, such as
the garage door opener, are equipped wit h
the rolling code .
"'Program the rolling code as follows:
Activating the garage door opener motor
unit
"'Locate the setting button on the garage
door opener motor unit . The exact location
and color of the button may vary depending
on the garage door opener manufacturer .
Homelink
163
"' Press the setting button on the garage door
opener motor unit (usually this will activate
a "setting light display" on the motor unit).
Now you will have about 30 seconds time to
perform the Homelink button programming
on the controls .
Programming on the controls
"'Press the Home link button that was already
programmed and hold for two seconds.
"'To end rolling code programming,
press and
hold the Homelink button for two seconds
again.
"'The Homelink button may need to be press-
ed a third time to end the adjustment
proce-
dure for some garage door openers .
After the controls have been programmed, the
garage door opener should recognize the
HomeLink signal and operate when the Home-
Link button is pressed. Now you may program
the other buttons as needed.
@
Tips
- Programming the rolling code can be
performed quicker and more easily with
the help of a second person.
- If difficulties should arise when pro-
gramming the rolling code, consult the
operating instructions for the garage
door opener or other devices for possible
solutions.
Advertisement
Table of Contents
