Table of Contents
Advertisement
162
Homelin
k
• To open the garage door, press the program-
med button . The LED@ will light up or
flash.
• To close t he garage door, pre ss the button
again.
@
Tips
To open the garage door, press the button,
but do not press it for longer ten seconds
or the Homelink module will switch to
programming mode.
Programming the transmitter
Applies to vehicles: with Home
link
Fig. 192 Dist ance between t he bumper and t he hand
t ransm itter
Programming: phase
1
on th e control unit
1. Switch on the ignit ion (do not start the
engine) .
2 . Press and hold both of the outer Home-
Link but tons ~ page 161, fig. 191 unt il
the LED @ turns off comple t ely (abo ut 20
seconds). Th is procedure clears the stand-
ard codes that were set at the facto ry a nd
does not need to be repeated again to
program the other buttons .
3 . Briefly press the Homelink button th at
you would like to program .
4 . Wait unti l the LED@ beg ins to blink
q uickly. The Homelink modu le will now
remai n in learning mode for 5 minu t es.
5. Now st and in fron t of your vehicle wit h
the orig inal hand t ransmit t er for t he ga -
rage door opener or for the device that
you would like to allocate to the Home-
Link button.
Programming: phase 2 on the bumper
6. Hold t he or iginal hand t ransm itter to-
war ds the left headlight and t he radiator
gr ille ~ fig. 192 .
7. Now activate (press) the hand transmit-
ter.
8. Pay attention to the turn signa ls for your
vehicle when activating the hand trans-
mitter . If the eme rgency flashers blink
three t imes, the programmi ng was suc-
cessf ul. If the e mergency flashe r on ly
blinks one t ime, t he 5 m inute time lim it
for t he adap tat ion has expired or the pro -
gramming was unsuccessful. Repeat the
programming from step 3 on the controls
o r select another distance from the
bumpe r.
9. If the garage door or other dev ices st ill
fail to be activated w it h the Home Link
control buttons after prog ramming is
comple t ed, it is possib le that these sys-
tems might be wor king wit h a rolling code
inst ead of the normal fixed code.
A
Roll-
ing code programming m ust be per-
formed ~ page 163 .
Progra m the remaining t wo buttons accord ing
to t he inst ructions ment io ned a bove. Beg in
similarly w ith the 3rd step if the program -
ming connec t ion was successful for the firs t
button.
Remote cont rol units for garage do or ope ne rs
in Canada are set to stop transmi tt ing radio
frequency signa ls after two seconds. This t ime
may not be suffic ient for the Homelink sys-
tem to learn the radio frequency signa l. Per-
form all other steps as desc ribed above.
Erasing the buttons
• Switch on the ignition (do not start the en-
gine).
• Press and hold both of the outer buttons un -
til the LED @ tu rns off completely (abo ut
20 seconds) to erase a ll of the buttons si-
mu lt aneously .
• Prog rammed buttons ca nnot be erased ind i-
vidually . Reprogram the buttons if necessa-
ry.
II>
Advertisement
Table of Contents
