Audi Q7 2014 Owner's Manual page 19

Table of Contents

Advertisement

In s trument
s and warnin
g/ indic a tor ligh ts
17
¢1.~
Trailer turn signal assembly
App lies to vehicles: with towing hitc h
The indicator light also blinks if the turn sig-
nal is operated when towing a trailer .
The indicator light .
blinks when the turn
signal is used, if a trailer has been properly
connected to the vehicle.
If one of the turn signal bulbs on the trai ler is
burned out or defective, the indicator light
will not blink when you use the turn signals.
{!)
Tips
For vehicles with a factory installed towing
hitch or a trailer hitch that was installed
later according to factory specifications,
the trailer tu rn signal assembly is actuat-
ed.
o
Malfunction Indicator Lamp (MIL)
The Malfunction Ind icator Lamp (MIL) is part
of the On-Board Diagnostic (OBD II) system.
The symbol
(.j
light s up when the ignition is
turned on and will turn off after the engine
has started and has sett led at a constant idle
speed. This indicates that the MIL is working
properly.
The warning light illuminates when there is a
malfunction in the engine electronic system .
Contact your authorized Audi dealer and have
the malfunction corrected .
An improperly clos ed fuel fill e r cap may also
cause the MIL light to illumi nate (onl y
vehicles with ga soline eng ine)
c:>
page 252.
For more informat ion
c:>
page 2 7.
Ci:> Adaptive Air Suspension
Applies to vehicles: with Adaptive Air Suspension
This
f!I
warning/indicato r light has the fol-
lowing functions:
- It illuminates for a few seconds after the ig-
nition is t urned on as function check and
then goes out .
- If the warning/indicator light illuminates or
blinks contin uously, there is a system fault
in the Adaptive Air Suspension. A system
fau lt can result in limited ride comfort and
low ground clea rance .
Drive safely to the
nearest authorized Audi dealer or qualified
workshop, and have the fault corrected .
- If the warning/indicator light flashes, you
should not drive the vehicle. The flashing
warning/indicator light points to an extreme
High level. A very pronounced lifting of the
vehicle (extreme High level) can result, for
examp le, when a heavy load is removed
from the vehicle. As soon as t he level has re-
turned to norma l, the warning/indicator
light stops flashing, and you can drive away.
- If the warning/indicator light flashes in con-
junction with the
II
warning/indicator
light, you should not drive off immediately
in order to prevent damage to the under-
body. The two warn ing/ indicator lights
flashing together points to an extreme Low
level. A very pronounced lowering of the ve-
hicle (extreme Low level) can result, for ex-
ample , from a heavy load. As soon as the
level has retu rned to normal, t he warn ing/
indicator lights stop flashing, and you can
drive away.
(D
Note
If the warning/ indicator light flashes in
conjunction with the
B
warning/ind ica-
tor light, you should not drive the vehicle
because low-lying vehicle parts can bot -
tom out as you drive over uneven ground
and be damaged as a result.
~
Adaptive Air Suspension
Appli es to vehicles: with Adaptive Air Suspension
This
B
warning/i ndicator light has the fol-
lowing functions:
- It illuminates for a few seconds after the ig-
nition is turned on as function check and
then goes out .
- It comes on for approximately 15 seconds
as a warning of
reduced ground clearance ,
if .,,.

Advertisement

Table of Contents
loading

Table of Contents