How To Manage: Error Codes - AEG BFS8500T User Manual

Problems with Wi-Fi signal
Possible cause
Trouble with wireless network signal.
New router installed or router configuration
changed.
The wireless network signal is weak.
The wireless signal is disrupted by another mi‐
crowave oven placed near the appliance.

12.2 How to manage: Error codes

When the software error occurs, the display shows error message.
In this section, you will find the list of the problems that you can handle on your own.
Code and description
C2 - the Food sensor is in the appliance cavity
during Pyrolytic Cleaning.
C3 - the door is not fully closed during Pyrolyt‐
ic Cleaning.
F111 - Food sensor is not correctly inserted in‐
to the socket.
F240, F439 - the touch fields on the display do
not work properly.
F601 - there is a problem with Wi-Fi signal.
TROUBLESHOOTING
Remedy
Check if your mobile device is connected to the
wireless network.
Check your wireless network and router.
Restart the router.
To configure appliance and mobile device
again, refer to "Before first use" chapter, Wire‐
less connection.
Move router as close to the appliance as possi‐
ble.
Turn off the microwave oven.
Avoid using another microwave oven and the
Remote Control of the appliance at the same
time. Microwaves disrupt Wi-Fi signal.
Remedy
Take out the Food sensor.
Close the door.
Fully plug Food sensor into the socket.
Clean the surface of the display. Make sure
there is no dirt on the touch fields.
Check your network connection. Refer to "Be‐
fore first use" chapter, Wireless connection.
83/272