Table of Contents
Advertisement
Problems with cleaning procedure
Description
There is too much water on
the bottom of the cavity after
cleaning.
Cleaning performance is not
satisfactory.
Power cut always stops cleaning. Repeat cleaning if it's interrupted by power failure.
12.2 How to manage: Error codes
When the software error occurs, the display shows error message.
In this section, you will find the list of the problems that you can handle on your own.
Code and description
F111 - Food sensor is not correctly inserted in‐
to the socket.
F240, F439 - the touch fields on the display do
not work properly.
F908 - the oven system cannot connect with
the control panel.
When one of these error messages continues to appear on the display, it means a faulty
subsystem may have been disabled. In such a case contact your dealer or an Authorized
Service Centre. If one of these errors occurs, the rest of the oven functions will continue to work
as usually.
Code and description
F131 - the temperature of the steamer sensor
is too high.
Possible cause
You put too much detergent in
the oven before you started
cleaning.
You started cleaning when the
oven was too hot.
You did not remove all the ac‐
cessories from the oven be‐
fore cleaning.
Fully plug Food sensor into the socket.
Clean the surface of the display. Make sure
there is no dirt on the touch fields.
Turn the oven off and on.
Turn the oven off and wait until it cools down.
Turn the oven on again.
TROUBLESHOOTING
Remedy
Next time evenly spread the
thin layer of a detergent on
the cavity walls.
Wait until the oven is cold. Re‐
peat cleaning.
Remove all the accessories
from the oven. Repeat clean‐
ing.
Remedy
Remedy
39/48
Advertisement
Table of Contents
