Toshiba MMD-UP0721HFP-UL Service Manual page 47

<Indoor unit address>
5
Push the TEMP.
6
Push the TIME
7
Push the button.
(It is OK if the display turns on.)
<Group address>
8
Push the TEMP.
9
Push the TIME
individual, set the address to
Individual : 0000
Header unit : 0001
Follower unit : 0002
10
Push the button.
(It is OK if the display turns on.)
11
Push the button.
The address setting is complete.
( SETTING flashes. You can control the unit after
<RBC-AWSU52-UL>
Operating LED
Lights while operating.
Pair the indoor unit to set and the remote controller one-to-one.
Turn on the power.
1
Press [ Menu] to open the "Menu"
2
Press and hold [ Menu] and [
 Press and hold 4 seconds.
3
In the "Field setting menu" screen, press [
4
Press [ ] and [ ] to select "Indoor unit" or "Outdoor unit", and the press [
 If "Indoor unit" was selected, the fans and lovvres of the indoor units operate.
When doing group connections:
 The fans and louvres of the selected indoor units operate.
<Line (system) address>
5
] to black highlight the item code (DN), and then press [
Press [
6
Press [ ] to black highlight the data, and then press [
(Match the address with the address on the interface P.C.board of the header outdoor unit in the same refrigerant line.)
7
After finishing setting the data of the item code (DN), press [
 "Continue?" is displayed.
/ buttons repeatedly to set the CODE No. to
/ buttons repeatedly to set an indoor unit address.
/ buttons repeatedly to set the CODE No. to
/ buttons repeatedly to set a group address. If the indoor unit is
0000 0000
0000 0000 0000
; header unit,
}
In case of group control
SETTING
Model name label
] at the same time to open "Field setting menu"
0001 0001
0001 0001 0001
; follower unit,
has disappeared.)
TA sensor selection
] and [ ] to select "DN setting", and then press [
] and [
] to set the data system address.
] and [
Set/Fix]
- 47 -
13 13 13 13 13
.
14 14 14 14 14
.
0002 0002
0002 0002 0002
.
Set/Fix]
Set/Fix]
] to set the item code No. to 12.