Toshiba MMD-UP0721HFP-UL Service Manual page 41

<RBC-AWSU52-UL>
1
Press [ Menu] to open the "Menu"
2
Press and hold [ Menu] and [
Press and hold 4 seconds.
3
In the "Field setting menu" screen, press [
4
Press [ ] and [ ] to select "Indoor unit" or "Outdoor unit", and the press [
 If "Indoor unit" was selected, the fans and lovvres of the indoor units operate.
When doing group connections:
 The fans and louvers of the selected indoor units operate.
5
] to black highlight the item code (DN), and then press [
Press [
6
Press [
] to black highlight the data, and then press [
SET DATA Handling of operation of air to air heat exchanger or ventilating fan
0000 0000 0000 0000 0000
0001 0001
0001 0001 0001
7
After finishing setting the data of the item code (DN), press [
 "Continue?" is displayed.
8
To set the data of other item codes (DN), press [
 The changes are fixed, and the "Field setting menu" screen returns.
 " " appears while data is changing.
When doing group connections:
 Press [ Return] to open the unit selection screen.
In the unit selection screen, press [
briefly display " ", and then return to the "Field
setting menu" screen.
2. Wiring
Relay (DC12V, procured locally)
Corresponds to the relay up
to one that the rated current
of the operation coil is approx. 75mA
CN32
1 1
FAN DRIVE
2 2
(2P WHI)
Indoor control
P.C. board
Note) Determine the cable length between the
indoor control P.C. board and the relay within 2m.
] at the same time to open "Field setting menu"
] and [ ] to select "DN setting", and then press [
] and [
Unavailable (At shipment)
Available
Set/Fix] To not do other settings, press [
Return] to
Outside control
input of fan
To terminal
- 41 -
Set/Fix]
] to set the item code No. 31.
] and [
] to set the data (At shipment : 0000).
Set/Fix]
Set/Fix]
Return]