Table of Contents
Advertisement
MN004478A01-AN
Chapter 7: Advanced Features
●
Press the Transmit Inhibit programmable button.
NOTE: If the user has disabled TX Inhibit using the menu and then moves the switch to the position
where TX Inhibit is enabled, the new value overwrites the menu value.
The display shows Tx inhibit on. You hear a sequence of short, low‐high tones to indicate that
transmission is inhibited.
Result: Pressing PTT triggers the radio sounds a constant short, low‐pitched tone (reject tone).
NOTE: The status of the Transmit Inhibit does not change after the radio powers up.
7.30.17.2
Disabling Transmit Inhibition
Procedure:
Perform one of the following actions:
●
Switch the preprogrammed Transmit Inhibit switch to Transmit Inhibit disabled position.
●
or to TxIn. Press the Menu Select button below TxIn.
●
Press the Transmit Inhibit programmable button.
NOTE: If the user has disabled TX Inhibit using the softkey and then moves the switch to the
position where TX Inhibit is enabled, the new value overwrites the menu value.
The display shows Tx inhibit off. You hear a sequence of short, high‐low tone (Transmit Inhibit Off
tone) to indicate that the transmission is back to normal operation.
7.30.18
General Radio Information
Use this menu item to view the general information of your radio.
The available information is:
●
Radio Information
●
IP Display
●
Control Assignments
●
Soft ID (if enabled)
7.30.18.1
Accessing the Radio Information
When and where to use: This feature displays the following radio information:
●
Host Version
●
Secure Version
●
Model Number
●
ESN
●
Flash Code
●
Tuning Version
●
Bluetooth Address
140
Advertisement
Table of Contents
