Table of Contents
Advertisement
MN004478A01-AN
Chapter 4: Status Indicators
You Hear
You See
A Long Tone
No phone
Phone busy
A Busy Tone
Phone busy
–
No acknowl-
edge
A High-
–
Pitched Tone
NOTE: You have the option of sending additional digits (overdial), such as an extension number, credit
card, or PIN numbers to the phone system. If the radio is preprogrammed for live overdial, every digit
entered after the call is connected, is sent to the phone system.
If the radio is preprogrammed for buffered overdial, the digits pressed are entered into memory and
then sent when the PTT button is pressed. Press the PTT button to send either digits or voice, but not
both at the same time.
4.9
Display Color Change On Channel
This feature provides visual channel identification for users to have a quick visual recognition on a particular
channel.
Your radio must be programmed to allow you to use this feature.
When changing channels, the radio backlight on top display, radio keypad, and accessories (DRSM or
keypad Mic) changes to the programmed color.
The backlight on top display changes to white. If connected to accessories, the DRSM backlight changes to
white and the keypad mic backlight changes to green for the following scenarios:
●
When changing to or powering up on invalid channels such as unprogrammed channels, receiver
frequency error channel and blank channels.
●
The radio is in radio stun or radio lock mode.
NOTE: Radio stun or radio lock mode is only applicable to Model 3.5.
For hard key zeroize, key loading, and scan list programming, the backlight follows the home channel
backlight color.
38
When
You press the PTT but-
ton and the phone sys-
tem is not available.
The phone system is
busy.
When a channel is not
available.
The call is not acknowl-
edged.
When you release the
PTT button.
Notes
Press
to hang up. The radio returns
to the Home screen.
Press
to exit the phone mode and try
your call later.
The radio automatically connects when a
channel opens.
Press
to hang up. The radio returns
to the Home screen.
The radio indicates to the landline party
that the caller may begin talking.
Advertisement
Table of Contents
