Transmit Inhibit; Enabling Transmit Inhibition; Disabling Transmit Inhibition - Motorola APX 8000XE User Manual

Hide thumbs Also See for APX 8000XE:

Table of Contents

MN002667A01-AR

Chapter 6: Advanced Features

6.24.12

Transmit Inhibit

This feature allows you to stops all transmission including voice and data. The radio can receive

messages but not able to reply the acknowledgment request of the received message.

This feature is available for APCO 25 trunking, Type II trunking and Conventional operations for all

APX radios.

You can physically control the transmission of the radio especially during operation in hazardous

environments. An environment is considered hazardous if radio transmission could initiate an explosion

or other dangerous reactions.

6.24.12.1

Procedure:

1 Press the Transmit Inhibit programmable button.

NOTICE: If the user has disabled TX Inhibit using the menu and then moves the switch

to the position where TX Inhibit is enabled, the new value overwrites the menu value.

The display shows Tx inhibit on. You hear a sequence of short, low-high tones to indicate

that transmission is inhibited.

Pressing PTT triggers the radio sounds a constant short, low-pitched tone (reject tone).

NOTICE: The status of the Transmit Inhibit does not change after the radio powers up.

6.24.12.2

Procedure:

1 Press the Transmit Inhibit programmable button.

NOTICE: If the user has disabled TX Inhibit using the softkey and then moves the switch

to the position where TX Inhibit is enabled, the new value overwrites the menu value.

The display shows Tx inhibit off. You hear a sequence of short, high-low tone (Transmit

Inhibit Off tone) to indicate that the transmission is back to normal operation.

Table of Contents