Edger Blade Replacement - Echo DPE-2100 Operator's Manual

Power edger
Table of Contents

Advertisement

MAINTENANCE

Edger Blade Replacement

Level 1.
Parts required: Blade, new split pin.
Note: Replace blade when it is bent, damaged, or worn shorter than
152.4 mm (6 in.).
Wear gloves or personal injury may result Gearcase and
surrounding area may be hot.
1.
Remove split pin (A).
2.
Align hole in inner blade
adapter (B) with notch in gear
housing, and insert locking tool
(G) to prevent PTO shaft (C)
from rotating.
3.
Remove L.H. blade nut (D) by
turning clockwise. Remove
outer blade adapter (E), and
blade (F).
4.
Install and center blade (F) on
inner blade adapter (B).
5.
Install outer adapter (E) and nut
(D). Tighten nut (D) firmly,
turning counterclockwise.
Note: Never reuse old split pin.
6.
Install new split pin (A) to secure nut, and bend both legs of pin
counterclockwise around PTO shaft (C).
34
DPE-2100
B
C
E
D
A
X7508310301
© 12/23 ECHO Incorporated
G
B
F

Advertisement

Table of Contents
loading

Table of Contents