Edger Blade Replacement - Echo DPE-2600 Operator's Manual

MAINTENANCE
Drive Shaft
1. Loosen clamping screw (B) and
remove locating screw (C). Pull
gear box and shield from drive
shaft housing.
2. Pull flexible cable (D) from the
drive shaft housing, wipe clean
and re-coat with 15 ml (0.5 oz.) of
grease.
3. Slide the flexible cable back in
the drive housing. DO NOT get
dirt on the flex cable.
4. Install the gear housing and shield assembly. Align locating screw hole
with hole in drive shaft housing.
5. Tighten screw securely.

Edger Blade Replacement

Level 1.
Parts required: Blade, new split pin.
Note: Replace blade when it is bent, damaged, or worn shorter than
152.4 mm (6 in.).
Wear gloves or personal injury may result Gearcase and
surrounding area may be hot.
1. Remove split pin (A).
30
DPE-2600
C C
B
D
B
X7508310600
© 03/23 ECHO Incorporated
G