IBM Elastic Storage System 3500 Service Manual page 24

Figure 20. Showing enclosure front view with shipping screws
2. Pull enclosure from the front until it reaches to the serviceable position.
a) Grab the ear caps (shown in Figure 20 on page 14) on the front left and right sides of the enclosure
front.
b) Slowly pull the enclosure forward until it locks into the serviceable position, which is accompanied
by an audible click.
c) The enclosure is extended into the serviceable position. Proceed to replace the bezel kit.
3. Remove and replace the left ear cap.
a) First, remove the left ear cap from the back side of the left flange by removing the two screws, as
highlighted in Figure 21 on page 14, by using a Phillips driver.
Figure 21. Displaying left ear cap front view
b) Next, install the left ear cap part (01LL677) as shown in Figure 22 on page 15.
14 IBM Elastic Storage System 3500: Service Guide