Toshiba MMY-MUP0721FT6P-UL Service Manual page 310

No. Part
3 WARNING
Heat
exchanger
Wear a pair of gloves.
Otherwise, you will risk an injury involving a replacement
part or some other object.
< 6ton, 8ton, High heat 6ton >
1. Detachment
1) Remove No. 1 Cabinet, No.2 propeller fan/fan motor,
No. 4 Inverter assembly (Waterproof cover assembly)
and No. 5 Reactor .
2) Remove the discharge cabinet, the two rear supports,
front support (right side), trans assembly, INV fix
support (up), INV fix support (left) and the motor base
and the four beams together.
(Fig.1 to 6)
Discharge cabinet
Motor base and Beams
Trans assembly
INV fix support (up)
INV fix support (left)
Rear supports
Front supports (right side)
Heat exchanger
< Remove Fin guard >
Fin guard (Right side)
M5 x 0.6" (16mm) : 6 pcs
< Remove Support>
After removing the screw, pull this
side forward to remove the hook.
Work procedure
: M5 x 0.4"(10mm), 8 pcs
: M5 x 0.4"(10mm), 17 pcs
: M5 x 0.4"(10mm), 17 pcs
: M5 x 0.4"(10mm), 17 pcs
: M5 x 0.4"(10mm), 17 pcs
: M5 x 0.4"(10mm), 6 pcs
: M5 x 0.4"(10mm), 6 pcs
: M5 x 0.4"(10mm), 5 pcs
Fin guard (Left side)
Fin guard (Back side)
M5 x 0.6" (16mm) : 6 pcs
M5 x 0.6" (16mm) : 6 pcs
Heat exchanger (Right side)
M5 x 0.4" (10mm) : 1 pcs
- 310 -
Trans assembly
M5 x 0.4" (10mm), 3 pcs
Front beams
M5 x 0.4" (10mm) : 4 pcs
INV fix support (left)
M5 x 0.4" (10mm) : 2 pcs
Back beams
M5 x 0.4" (10mm) : 4 pcs
Rear support (Right side) Rear support (Left side)
M5 x 0.4" (10mm) : 3 pcs M5 x 0.4" (10mm) : 3 pcs
Fig.5
Remarks
Discharge cabinet
M5 x 0.4" (10mm), 8 pcs
Fig.1
Right beams
M5 x 0.4" (10mm) : 4 pcs
INV fix support (up)
M5 x 0.4" (10mm) : 2 pcs
Fig.2
Front support (Right side)
M5 x 0.4" (10mm) : 3 pcs
Fig.3
Left beams
M5 x 0.4" (10mm) : 5 pcs
Fig.4
Heat exchanger (Left side)
M5 x 0.4" (10mm) : 4 pcs
Fig.6