Travel Adjustments - Scag Power Equipment PATRIOT SPZ-52H-22FX Operator's Manual

R

6.2 TRAVEL ADJUSTMENTS

Neutral or tracking adjustments will need to be made if:
A. The steering control levers are in the neutral
position and the machine creeps forward or backward.
(See Neutral Adjustment).
B. The steering control levers are in the full forward
position and the mower pulls to one side or the other
when traveling in a forward direction. (Tracking
Adjustment, See Page 27).
NEUTRAL ADJUSTMENT
1. Be sure the dump valve levers are in the run position
and the steering control levers are in the neutral lock
position.
2. With an operator in the seat, start the engine and
disengage the parking brake.
MOVE STEERING LEVER OUT
TO THE NEUTRAL POSITION
ADJUST HERE
TRACKING ADJUSTMENT
BOLT
Figure 6-3. Steering Control Rod Adjustment
26
3. Run the engine at full operating speed and check if
the machine creeps forward or backwards.
4. Adjust the RH wheel by loosening the jam nuts on
the steering control rod and turning the adjustment
nut until the drive wheel turns in the forward
direction. Turn the adjustment nut back until the
drive wheel stops moving. Turn the adjustment nut
an additional 1/2 turn. See Figure 6-3.
5. Tighten the jam nuts and repeat for the LH wheel.
See Figure 6-3.
6. Actuate the steering control levers forward and
reverse several times and return them to the neutral
position.
7. Check that the drive wheels remained in neutral and
readjust if necessary.
LOOSEN THE
JAM NUT
Section 6