Section 6 - Adjustments; Parking Brake Adjustment; Travel Adjustments - Scag Power Equipment SCZII-61V-36BV Operator's Manual

R

6.1 PARKING BRAKE ADJUSTMENT

WARNING
Do not operate the mower if the parking brake is
not operable. Possible severe injury could result.
The parking brake linkage should be adjusted whenever
the parking brake lever is placed in the "ENGAGE" position
and the parking brake will allow the mower to move. If
the following procedures do not allow you to engage the
parking brake properly, contact your authorized Scag
Power Equipment dealer for further brake adjustments.
1. Position a floor jack under the rear of the machine.
Raise the machine and support it to prevent it
from falling. Block the caster wheels to prevent the
machine from moving.
2. With the brake in the engaged position, check the
distance between the notch on the brake actuator
rod and pivot bushing on the LH side of the machine.
The distance should be 1/8". See Figure 6-1.
3. If the distance is not at the specified measurement,
turn the adjustment nut on the brake actuator rod
until the 1/8" measurement is achieved. See Figure
6-1.
4. Repeat steps 2-3 on the RH side of the machine.
5. Test the brake.
- NOTE -
If this procedure does not achieve proper brake
adjustment, please contact your authorized Scag
dealer.
ADJUSTMENT NUT
Figure 6-1. Brake Adjustment
ADJUSTMENTS

6.2 TRAVEL ADJUSTMENTS

Neutral or tracking adjustments will need to be made if:
NEUTRAL ADJUSTMENT
1. Be sure the dump valve levers are in the run position
2. With an operator in the seat, start the engine and
3. Run the engine at full operating speed and check if
4. If the machine creeps either forward or backward, a
5. Before making an adjustment, Position a floor jack
6. To adjust the RH side, make sure the control levers
1/8"
Figure 6-2. Steering Control Linkage Adjustment
30
A. The steering control levers are in the neutral
position and the machine creeps forward or backward
(Neutral Adjustment).
B. The steering control levers are in the full forward
position and the mower pulls to one side or the
other when traveling in a forward direction (Tracking
Adjustment).
and the steering control levers are in the neutral lock
position.
disengage the parking brake.
the machine creeps forward or backwards.
neutral adjustment will need to be done.
under the rear of the machine. Raise the machine
and support it to prevent it from falling. Block the
caster wheels to prevent the machine from moving.
are in the neutral lock position. Then remove the
wheel, loosen the jam nut on the control arm, and
adjust the control rod until the control plates on the
transaxle are centered in neutral. See Figure 6-2.
LOOSEN JAM NUT
ADJUST HERE
CONTROL PLATES
CENTERED IN NEUTRAL
Section 6