Section 6 - Adjustments; Parking Brake Adjustment; Travel Adjustments - Scag Power Equipment STCII-48V-26MX Operator's Manual

R

6.1 PARKING BRAKE ADJUSTMENT

WARNING
Do not operate the mower if the parking brake
is not operable. Possible severe injury could
result.
The parking brake linkage should be adjusted whenever
the parking brake lock latch is placed in the "ENGAGE"
position and the parking brake will not prevent the mower
from moving. If the following procedures do not allow you
to engage the parking brake properly, contact your Scag
dealer for further brake adjustments.
1. Park the machine on a flat surface and block the
caster wheels to prevent the machine from moving.
Remove the ignition key.
2. Engage the parking brake. Fully depress the brake
pedal and pull the parking brake lock latch back to
lock the parking brake. See Figure 6-1.
3. Loosen the jam nut at the front of the brake linkage.
See Figure 6-2.
4. With the parking brake in the locked position, turn
the adjustment nut until the brake spring has an
overall length of 2". See Figure 6-2.
5. Repeat steps 3 and 4 on the other side of the
machine.
6. Test the parking brake.
- NOTE -
If this procedure does not achieve proper brake
adjustment, please contact your authorized Scag
dealer.
ADJUSTMENTS
LOOSEN JAM
NUT

6.2 TRAVEL ADJUSTMENTS

Neutral or tracking adjustments will need to be made if:
A. The steering control levers are in the neutral
position and the machine creeps forward or backward.
(Neutral Adjustment, See Page 26).
B. The steering control levers are in the full forward
position and the mower pulls to one side or the
other when traveling in a forward direction. (Tracking
Adjustment, See Page 26).
26
PULL BACK ON
PARKING BRAKE
LATCH
PUSH BRAKE
PEDAL FORWARD
Figure 6-1. Brake Adjustment
2" WITH PARKING
BRAKE ENGAGED
Figure 6-2. Brake Rod Adjustment
Section 6
ADJUST HERE