Preface - Siemens SICAM V01.00 Manual

Preface

Purpose of the Manual
This manual describes the application, functions, installation, commissioning, and operation of the SICAM
Fault Sensor Indicator V2.0 B-Sensor (6MD2314-2Bxx0).
Target Audience
This manual is intended for project engineers, commissioning engineers, and operating personnel in electrical
systems and substations.
Scope
This manual is valid for the SICAM Fault Sensor Indicator V2.0 B-Sensor (6MD2314-2Bxx0).
Indication of Conformity
FCC Conformity Information
This device complies with FCC part 15 subpart B of the FCC rules. Operation is subject to the following 2
conditions:
•
This device may not cause harmful interference.
•
This device must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to FCC part 15 subpart B of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the user will be required to correct the
interference at their own expense.
SICAM, Fault Sensor Indicator V2.0 B-Sensor, Manual
E50417-H8940-C656-A1, Edition 08.2023
This product complies with the directive of the Council of the European Communities
on the harmonization of the laws of the Member States relating to electromagnetic
compatibility (EMC Directive 2014/30/EU) and concerning electrical equipment for use
within specified voltage limits (Low Voltage Directive 2014/35/EU) as well as restriction
on usage of hazardous substances in electrical and electronic equipment (RoHS Direc-
tive 2011/65/EU).
This conformity has been proved by tests conducted by Siemens AG in accordance of
the Council Directive in accordance with the product standard IEC/EN 61326-1 for the
EMC directives, and with the standard IEC/EN 61010-1 for the low-voltage directive.
RoHS directive 2011/65/EU is met using the standard IEC/EN 63000.
The device has been designed and produced for industrial use.
3