Table of Contents
Advertisement
9 Manufacturer's information
9 Manufacturer's information
9.1 Delivery
● Check that all parts are present and check for any damage
immediately upon receipt.
The product's performance is tested at the factory. The scope
of delivery is apparent from the dispatch documents and the
design from the order number.
9.2 Packaging
The product is packaged in a cardboard box which can be re-
cycled as paper.
9.3 Transport
1. Only transport the product by suitable means. Do not drop.
Handle carefully.
2. After the installation dispose of transport packaging ma-
terial according to relevant local or national disposal regu-
lations / environmental protection laws.
9.4 Storage
1. Store the product free from dust and moisture in its ori-
ginal packaging.
2. Avoid UV rays and direct sunlight.
3. Do not exceed the maximum storage temperature (see
chapter "Technical data").
4. Do not store solvents, chemicals, acids, fuels or similar
fluids in the same room as GEMÜ products and their spare
parts.
10 Assembly and installation
1. Observe the national regulations and provisions.
2. Observe the installer provisions.
3. Lay cables securely and protect them from damage.
4. Connect open wire ends in a junction box with protection
class IP20 and higher or outside the EX area
10.1 Preparations for installing the valve (linear
actuator)
1. Move the actuator A into zero position (actuator vented).
2. Remove optical position indicator 2 and / or protective cap
1 from the actuator top.
1
GEMÜ 4240
10.2 Information on use in damp conditions
The following information is intended to help when installing
and operating the product in damp conditions.
1. Lay cables and pipework so that no condensate or rain
water that remains on the pipework / cables can enter the
cable glands or plugs of the product.
2. Check that all cable glands or plugs are positioned cor-
rectly
3. Check the sealing ring 1 for any damage and correct posi-
tioning before tightening the cover.
10.3 Mounting kit assembly
Item
1
2
3
4
5
6
* Included depending on version.
Pretensioned spring!
▶ Damage to the device.
Slowly release the tension in the spring.
●
Do not scratch the spindle!
▶ A damaged spindle surface may cause failure of the
travel sensor.
2
A
10 / 23
Name
Item
Spindle
7
Spring
8
Operating bush
9
Distance piece
10
O-ring
11
Adapter
CAUTION
CAUTION
1
Name
Flange plate
Screws
Pressure disc*
O-ring*
O-ring*
www.gemu-group.com
Advertisement
Table of Contents
