Advanced Dvcp Policy Configuration Dialog Box; Advanced Dynamic Nat Dialog Box - Watchguard Firebox X1000 Reference Manual

Advanced DVCP Policy Configuration dialog box

Advanced Dynamic NAT dialog box

Reference Guide
Internal IP Address
Enter the final destination of incoming packets on the Trusted
network.
Set internal port to different port than service
This feature is rarely used. It enables you to redirect packets to not
only a specific internal host but also to an alternative port.
Internal Port
If you enable the above checkbox, enter the final port destination
of incoming packets to the Trusted network.
OK
Closes this dialog box and saves any changes.
Allow access to
Select or enter the host or network and port/protocol/client port
you want to allow access via DVCP.
Dst Port
Enter a port number to restrict the routing policy to a single
destination port.
Protocol
Select a protocol type to restrict the routing policy to a particular
protocol.
Src Port
Enter a port number to restrict the routing policy to a single
source port.
OK
Closes this dialog box and saves any changes.
Dynamic NAT
List the hosts for which dynamic NAT will be disabled.
Add
Click to add a host.
Policy Manager
165