Table of Contents
Advertisement
TROUBLESHOOTING
Most treadmill
prob{ems
can be solved
by following
the simple
steps
below.
Find the symptom
that
applies,
and follow
the steps
listed.
If further
assis-
tance
is needed,
see the front cover
of this manual
SYMPTOM:
The power
does
not turn on
Make sure that the power
cord is plugged into a
surge suppressor
and that the surge suppressor
is
plugged into a properly-grounded
outlet (see page
13). Use or, ly a single-outlet
surge suppressor
that
meets
all of the specifications
described
on page
13. IMPORTANT:
The treadmill
is not compat-
ible with GFCl-equipped
outlets
and may not be
compatible
with AFCl-equipped
outlets.
b.
After the power
cord has been plugged in. make
sure that the key is inssded
into the console.
Check
the power switch
located
on the treadmill
frame near the power cord. If the switch protrudes
as shown,
the switch
has tripped.
To reset the
power
switch,
wait for five minutes
and then press
the switch back in,
Tripped
Reset
SYMPTOM:
The power
turns
off during
use
a.
Check
the power switch
(see the drawing
above).
If the switch has tripped,
wait for five minutes
and
then press the switch
back in.
b.
Make sure that the power
cord is plugged
in. If the
power cord is plugged
in, unplug
if, wait for five
minutes,
and then
plug it back in.
c.
Remove
the key from the consols, and then
reinsert
it.
d,
If the treadmill still wilt not run, please
see the front
cover of this manual.
SYMPTOM:
The console
displays
remain
lit when
you remove the key from the console
a,
3he console features
a display
demo mode, de-
signed to be used if the treadmill
is displayed
in a
store.
If the displays
remain lit when you remove
the key, the dome
mode is turned
on. To turn oil
the demo
mode, hold down the Stop button for a
few seconds.
If the displays are still lit, see THE
INFORMATION
MODE on page 18 to turn off the
dome
mode.
SYMPTOM: The displays of the console do not
function properly
a.
RemovethekeyfromtheconsolsandUNPLUG
THE POWER
CORD.
Next, remove
the five indi-
cated #B x 3/4" Screws
(4).
Carefully
lift the Motor Hood (48) upward_ and then
slide it forward
and off. Make sure that the Motor
Hood does not get caught
bythe
tabs on Ibe sides
of the Motor Hood.
2O
Advertisement
Table of Contents
