Advertisement
TROUBLESHOOTING
Most treadmill
problems
can be solved by following
the simple steps below. Find the symptom
that
applies, and follow the steps listed. If further assistance
is needed,
call toll-free 1-8O0-4-MY-HOME
®
(1-800-469-4663).
PROBLEM: The power does not turn on
SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor
is plugged into a properlygroundedoutlet (see page 9). Use only a single-outletsurge suppressor
that meets all of the specifications described on page 9. Important:The treadmillis not compatible
with GFCl-equipped outlets.
b. After the power cord has been plugged in, make sure that the key is fully inserted intothe console.
C.
Check the reset/offcircuit breaker located on the
treadmill near the power cord. If the circuit breaker
protrudes as shown, the breaker has tdpped. To
reset the circuitbreaker, wait for five minutes and
then press the breaker back in.
Reset_
PROBLEM: The power turns off during use
SOLUTION: a. Check the reset/offcircuit breaker located on the treadmillframe near the power cord (see c.
above). If the circuit breaker has tdpped, wait for five minutesand then press the breaker back in.
b. Make sure that the power cord is plugged in. Ifthe power cord is plugged in, unplug it, wait for
five minutes, and then plug it back in.
c. Remove the key from the console. Reinsert the key fully into the console.
d. If the treadmillstill will not run, call toll-free 1-800-4-MY-HOME ®(1-800-469-4663).
PROBLEM: The speed display on the console does not function properly
SOLUTION: a. Remove the key and UNPLUG THE POWER CORD.
Carefully lower the Uprights (64) to the floor. Remove
the three indicated Small Screws (37).
Raise the Uprights (64) to the vertical position. Pivot
the Hood (1) off.
a
64
•
37
24
Advertisement
