Table of Contents
Advertisement
Search function does not
operate during playback.
Search function operates
| suddenly during playback.
Search function stops.
The tape operation buttons do
not operate while writing the
start ID.
The absolute time codes cannot
be written.
End ID cannot be written during
playback.
Renumbering function does not
operate.
Start ID cannot be erased.
Skip ID cannot be erased.
End ID cannot be erased.
seconds (18 seconds in the long-play
the long-play mode) from the end of
mode) from the end of another start ID. | another start ID.
The start ID is not written correctly.
Erase it (page 29), and then write it
again.
The portion between the end of a start ID| When writing the start [Ds manually, write
and the beginning of the following start | so that the intervals between them are
ID is less than 9 seconds (18 seconds in | more than 9 seconds (18 seconds in the
the long-play mode) long.
long-play mode).
The selected program number does not
exist on the tape.
Use the RENUMBER button to re-arrange
The program numbers are out of order.
the program numbers (page 31).
The skip play function is operating.
Turn off the indicator by pressing SKIP
(The SKIP PLAY indicator lights in the
PLAY.
display window.)
The repeat play function is operating.
Turn off the indicator by pressing
REPEAT 1/ALL.
There is a blank section between
Use the end search function (page 24)
selections. (The sampling frequency
when recording so that no blank is
indicator blinks on the display window.) | created.
While writing the start ID (9 seconds or | Operate after the start ID is written.
18 seconds), none of the buttons except
the & button are operative.
Recording was started from the blank
Rewind the tape to the beginning, or
section.
locate the very last point of the previous
recording, using the end search function
(page 24), and start recording from the
point.
The portion where you want to write the | Set the deck in the record-pause mode
end ID is blank.
by pressing @ REC, then write the end
ID.
¢ The portion between the end of a start
| ¢When writing the start IDs manually,
ID and the beginning of the following
write so that the intervals between them
start ID is less than 9 seconds (18
are more than 9 seconds (18 seconds
seconds in the long-play mode) long.
in the long-play mode).
¢ The start ID is written near the end of
| Erase the start ID near the end of the
the tape.
tape.
The portion between the end of a start
|When writing the start IDs manually,
ID and the beginning of the following
write so that the intervals between them
start ID is less than 9 seconds (18
are more than 9 seconds (18 seconds
seconds in the long-play mode) long.
in the long-play mode).
Two skip IDs are written continuously.
When writing the skip IDs, write so that
the intervals between them are more than
1 second (2 seconds in the long-play
mode).
The end ID is written at the beginning of | Start recording from the beginning of the
the tape.
tape.
The end ID is written immediately after a | First erase the start ID.
start ID.
Advertisement
Table of Contents
