Table of Contents
Advertisement
Program Numbers
Program numbers are the codes indicating the selection
order. (See page 26 for details.)
4
Designate the next program number (the number
There are two ways to write program numbers:
that follows the program number of the last
© Writing automaticatly during recording
selection) with the numeric button.
¢ Renumbering automatically during playback or in the
If you are not aware of the program number, press the
stop mode (Renumbering function)
KJ button to check the last program number
(After
checking the program number, locate the last point of
the previous recording, using the end search
Writing
A
ically
D u r i n g
Recordin
function)
Rung
eutomatically,
Punng
Heceraing
if the program number of the last selection appears at
the PGM NO. display. you need not to designate the
next number.
When you proceed so that start IDs are written
automatically during recording, the program numbers are
also written.
PGM
Next program number
Writing program numbers from the beginning of the
tape
5
Press the §§ PAUSE or B> (play) button.
1
Haglan hide pre' rhea
lit. If it is not, press
The program numbers are written for about 9 seconds
.
ergy
(about 18 seconds in the long-play mode)
When turning on the power and inserting a cassette
consecutively, beginning from the designated number
with its safety tab at the record-possible position, the
AUTO indicator lights. In timer recording. the AUTO
indicator will be the same as the one before the power
is turned off.
if the next program number Is not designated in step 4
The start IDs will be written, but the program numbers will
The program numbers will be written in numerical
order from *1" at the same position as the start IDs.
Writing program numbers from the middle of the tape
1
To locate the fast point of the previous recording,
using the end search function. (See page 24.)
It is important to proceed with the end search function
in order not to leave a blank section on the tape.
2
The AUTO Indicator must be lit. If it is not, press
the START ID AUTO button.
When turning on the power and inserting a cassette
with its safety tab at the record-possible position, the
AUTO indicator lights.
In timer recording, the AUTO indicator will be the same
as the one before the power is turned off.
3
Press the @ REC button to set the deck in the
record-pause mode.
30
Advertisement
Table of Contents
