Sony DTC-60ES Operating Instructions Manual page 12

|Moxer:halelamlarem al elalertre)lame)mOrelalige) i)
Display Window
TE] REMAINING
POM TIME
roc eras [a]
6.08. Ou.
AM = 32kHz
44 tkHz
PM 48kHz
TOP r MID ry
STEP/PGM NO. indicator
Shows the program number of the selection being
played. When programming the desired selection with
the RMS operation (page 39), the display shows the
step number of the programmed selection.
COPY PROHIBIT indicator
Lights when recording the digital signal with the copy
prohibit code. In this case, record with the LINE IN
jacks.
START ID indicator
Flashes when writing (for 9 or 18 seconds) or erasing a
start ID code, and lights when the start ID is detected
during playback.
SKIP ID indicator
Lights when writing (for 1 or 2 seconds) or erasing a
skip ID code or when the skip ID is detected during
playback.
MARGIN indicator
Shows how much margin there is between the peak
level of input audio signal and 0 dB.
REHEARSAL indicator
Lights while the rehearsal function is activated (page
29).
12
OIGITAL IN
Peel |
—
REPEAT 1 | DISPLAY | MUSIC SCAN i
ALL OFF AUTO | SKIPPLAY START — A |
RMS_AMS Renu BER
Waite € |
— SKIPID —
| warre erase |
" END 1D
| WRITE ERASE |
END
(25) Peak level meters/Frequencies map
Indicate the signal levels during playback and
recording. There are separate meters for each left and
right channel. These meters have a peak hoid function
which indicates the peak level momentarily
When pressing the 4 button while keeping the
COUNTER MODE button pressed. the sampling
frequencies with which the tape was recorded 's
displayed (page 35).
Tape operation indicators
[REC]: Lights during recording or in the record-pause
mode.
B ; Lights during recording or playback It also lights
in the record-pause mode or in the play-pause
mode.
Bf : Lights in the record-pause mode or in the piay-
pause mode.