Memory Writing - Icom IC-RSOOCOL Instruction Manual

41
8 MEMORY CHANNELS
8-2 MEMORY WRITING There are 2 ways to write a memory channel,
(1) Writing in the operating frequency section. You can
perform memory writing when any screen is selected.
However, the original memory contents are erased.
(2) Writing in the memory list screen. Original memory
contents are not erased.
(1) IN THE OPERATING 1) Select the memory channel:
FREQUENCY SECTION - Use the [DN UP] selector or the keyboard. See p. 39
for details.
2) Set the frequency, mode, filter width and tuning step.
3) Push and hold the [WRITE] switch until the receiver
emits 3 beeps.
Memory writing is completed.
(2) IN THE MEMORY LIST 1) Set the frequency, mode, filter width and tuning step.
SCREEN
2) Access the memory list screen:
- Push [F-2] "MEMO" when the menu 1 screen is
displayed,
3) Push and hold [F-1] '"'ROLL" then rotate the main dial
to select the desired memory channel.
4) Push and hold the [WRITE] switch until the receiver
emits 3 beeps.
Memory writing is completed without erasing original
contents.
@MEMORY WRITING IN THE MEMORY LIST SCREEN
mH MIDE orn
$497.057.00 207%
TS 12.Ssne
7H WIDE or
397.057.00 e070
TS 12.5ame
Memory channel selected "ROLL" and The contents are written into the memory
the main dial. list screen.