JVC HR-S10EG Service Manual page 29

DUBBING CONNECTOR
(TAPE-TO-TAPE EDITING AND A/V CONNECTION TO A TELEVISION)
A dubbing connector is provided with the recorder to
enable it to be connected to another video recorder for
editing, or to a television equipped with A/V input con-
nectors, without using the Tuner/Adapter.
@ When the tuner is used in combination with the re-
corder, this dubbing connector is not needed. For edit-
ing operations using the tuner, refer to the instruction
manual for the TU-S10EG/EK.
Installing the dubbing connector to the recorder
HR-S10EG/EK (rear view)
Direct connector section
@ Video input connector
(EINGANG)
'Video output connector
(AUSGANG)
'Audio input/output
Insert plugs correctly.
socket
Connection for editing ]
[ Connection
television via A/V connectors
'® Using the HR-S10EG/EK as a playback deck
Use one of power supply units (see page 7).
To VIDEO AUSGANG
malt
To AUDIO socket
' Using the HR-S10EG/EK as a recording deck.
© Use one of power supply units (See page 7).
To VIDEO EINGANG
HR-S10EG/EK conn
1.
To AUDIO socket
HR-S10EG/EK Recording deck
Playback deck
Caution
© Copyrighted material must not be copied.
@Tape-to-tape editing may cause slight deterioration of pic-
ture quality.
© If you connect a video camera to the side panel CAMERA/
KAMERA connector during tape-to-tape editing, the
camera signal will be automatically recorded.
This connection permits direct playback with a televi-
sion equipped with A/V input connectors. As a power
source, use the AC-P3EG/EK, NB-P4U, NB-P3U or
AP-P3E.
HR-S10EG (rear view) Television (rear view)