Before Using This Unit; Setting The Voltage Selector (Worldwide Models Only); Installing The Remote Controller Balteries; Using The Remote Controller - Onkyo TX-DS797 Instruction Manual

Before using this unit
Setting the Voltage selector
(Worldwide models only)
Worldwide models are equipped with a voltage selector m conform
with local power supplies. Be sure 1o set this switch to match the
voltage of the power supply in your area before plugging in the unit.
Determine the proper voltage for your area: 220-230 V or 120 V.
If the preset voltage is no1 con'ect for your area, insert a screwdriver
into the groove in the switch. Slide the switch all the way to the
upper (120 V) or to the lower (220-230 V), whichever is appropriate.
I Using the remote controller
Point the remote controller Ioward the remote control sensor. The
STANDBY indicator lights up when the unit receives a signal from
the remote controller.
Remote control sensor
TX-DS797
STANDBY indicator J
VOLTAGE
SELECTOR
J
Approx. 16 feet
(5 meters)
I Installing the remote controller batteries
1. Remove the battery compartment cover by pressing
and sliding the cover,
2. Insert two AA (R6 or UM-3) batteries into the battery
compartment. Carefully follow the polarity diagram
(positive (+) and negative (-) symbols) inside the
battery compartment.
3. After batteries are installed and seated correctly,
replace the compartment cover.
Notes:
• Place the unit away from slrong light such as direct sunlight or
inverted fluorescent light which can prevent proper operation of
the remote controller.
• Using anolher remote controller of the same type in the same
room or using the unit near equipment which uses infrared rays
may cause operaliona[ interference.
• Do not put objects on the remote controller. Its buttons may be
pressed by mistake and drain the batteries.
• Make sure the audio rack doors do not have colored glass,
Placing the unit behind such dooz:s may prevent proper remote
controller operation.
• If there is any obstacle between the remote controller and the
remote control sensor, the remote controller will not operate.
Notes:
• Do no1 mix new batteries with old batteries or different kinds of
batteries.
• To avoid corrosion, remove the batteries if 1he remote controller
is no1 to be used for a long time.
• Remove dead batleries immediately to avoid damage from
corrosion. If the remote controller does not operate smoothly,
replace both the halteries at the same time.