Erasing The Programmed Command; Erasing All The Commands Programmed; From One Button - Onkyo TX-DS797 Instruction Manual

Programming the commands of remote controllers for other devices into the
remote controller
SEND/LEARN
indicator
MODE
bu_ons
ENTER
Erasing the programmed command from one
button
You can only erase memorized commands and not preset ones.
1.
Press and hold down the desired MODE button for
the command, press the ENTER button, and then
release both buttons.
When you press the MODE button, the SEND/LEARN indicator
lights. When you press the ENTER button, the lamp turns oft'.
When you release the buttons, the lamp lights again.
2.
Press and release the button for the command you
wish to erase.
When you press the button, the SEND/LEARN indicator turns
off. When you release the button, the lamp lights again.
3. Press and release the same button again.
The SEND/LEARN lamp flashes twice slowly. The memorizod
command is erased.
Note:
If no button is pressed for more than 30 seconds during the erasing
procedure, the SEND/LEARN indicator flashes three times quickly,
and the remote controller exits the erasing mode. Resmne from Step
1.
SEND/LEARN
,,,.,.,._,_,...,_ indicator
MODE
buttons
ENTER
Erasing all the commands programmed under a
MODE button
1. Press and hold down the desired MODE button,
press the ENTER button twice, and then release both
buttons.
2.
When you press the MODE button, the SEND!LEARN indicator
lights. When you press the ENTER button, the lamp turns off.
When you release the buttons, the lamp flashes twice slowly and
then lights again.
Press and release the same MODE button again.
When you release the button, the SEND/LEARN indicator
flashes twice slowly. This erases all the commands memorized
Io the MODE button.
Notes:
• If no button is pressed for more than 30 seconds during the
erasing procedure, the SEND!LEARN indicator flashes three
times quickly and the remote controller exits the erasing mode.
Resume from Step 1.
• If you perform an invalid operation during erasing, the SEND/
LEARN indicator flashes three times quickly, and the remote
controller exits 1he erasing mode. Resume from Step 1.
• If many commands have been programmed to the MODE
button, then the SEND!LEARN indicator may remain lit for up
to 20 seconds during Step 2. This is not a malfunction.
66