Connecting Antennas; Assembling The Am Loop Antenna; Connecting The Am Antenna Cable; Connecting The Included Antennas - Onkyo TX-DS797 Instruction Manual

Connecting antennas
To use lhe tuner of TX-DS797, it is necessary to prepare the supplied
FM and AM antennas.
• Adjustment and placement of the FM and AM antennas for
better reception must be done while listening to a station
broadcast.
• If better reception cannot be obtained, then placement of an
outside antenna is recommended.
I Assembling the AM loop antenna
Assemble the loop antenna as shown in the illustration.
• Refer to "Connecting the AM loop antenna" below for details on
connecting the loop antenna.
Connecting the included antennas
Connecting the FM indoor antenna:
The FM indoor antenna is for indoor use only. During use, extend the
antenna and move it in various directions until the clearest signal is
received. Fix it with push pins or similar implements in the position
thai will cause the least amount of distortion.
If the reception is not very clear with the attached FM indoor
antenna, lhe use of an ouldoor antenna is recommended.
Connecting the AM loop antenna:
The AM loop anlenna is for indoor use only. Set it in the direction
and position where you receive the clearest sound. Put it as far away
as possible from the TX-DS797, televisions, speaker cables, and
power cords.
When reception is not satisfactory with the attached AM loop
antenna alone, connection of an ouldoor antenna is recommended.
@
Insert into the hole.
I Connecting the AM antenna cable
1. Press down the lever.
2. Insert the wire into the hole.
3. Release the lever.
1
2 3
FM antenna
Other models
(Indoor)
AM loop antenna
Strip away the
insulation from the end
of the cable, then fully
insert the stripped end
of the cable.
Hint:
Either of the split ends of the AM antenna can be connecled to either
terminal. Unlike speaker cabling, there is no polarity for AM
broadcast signals.
24