Onkyo TX-DS797 Instruction Manual page 13

Rear panel facilities
] PRE OUT
These jacks are for connecting auxiliary power amplifier.
Using auxiliary power amplifiers allows you to lislen at louder
volumes than with the TX=DS797 alone. If power amplifiez_s are
used, connect each speaker to the corresponding power amplifier.
Front input
R (red)
Subwooter
Surround
back
R (red)
Power amplifier
1. Front left speaker
2. Front right speaker
3. Subwoofer
4. Surround back left
speaker
5. Surround hack right
speaker
6. Surround left speaker
7. Surround right speaker
8. Center speaker
] ANTENNA
These jacks are for connecting the FM indoor antenna and AM loop
antenna that are supplied with the TX=DS797.
] AUDIO IN/OUT
These are the analog audio inpels and oulputs. There are eight audio
inputs and 3 audio outputs. The audio inputs and outputs require
RCA-type connectoz_s.
• When connecting a VCR or olher video component, make sure
you connect the audio and video leads together (Le., both to
VIDEO 3).
• The PHONO (PH) inpet jacks on 1he TX-DS797 is designed for
use with turntables that use moving magnet cm_tridges.
RCA type
] MONITOR OUT
The monitor output includes both composite video and S video
configurations. This oulput is for connecting television monitors or
projectors.
] ZONE 2 AUDIO/VIDEO OUT
Connect the device that will be used in the remote zone (Zone 2). For
more information regarding how 1o make the connections, refer to
"Connecting the remote zone (Zone 2) speakers" on page 21.
] COMPONENT VIDEO INPUT/OUTPUT
If your DVD player or other device has component video
connectors, be sure to connect them to these component video
connectors on the TX=DS797. The TX-DS797 has two component
video input connectoz_s to obtain the color information (Y, PB, PR)
directly from the recorded DVD signal or other video component
and one component video output connector to output it directly into
the matrix decoder of the display device. By sending the pure DVD
component video signal directly, the DVD signal forgoes the extra
processing that normally would degrade the image. The result is
vastly increased image quality, with incredibly lifelike co[oz_s and
crisp detail.
Y PB PR RCA type
] SPEAKERS
Six terminals m'e provided for the front left, front right, front center,
surround left, surround right, and surround back speakers. Speaker
outputs are compatible with banana plug connectors (other than
European models).
] ACOUTLETS
The TX=DS797 is supplied with AC mains outlets for connecting the
power cords from other devices so that their power is supplied
through the TX=DS797. By doing this, you can use the STANDBY/
ON button on the TX=DS797 to turn on and off the connected
devices as well.
The shape, number, and total capacity of the AC outlets may
differ depending on the area of purchase.
Caution:
Make sure that the total capacity of the other components connected
to this unit does not exceed the capacity that is printed on the rear
panel (e.g., 120 watts).
European and some USA and Canadian
Asian models models
] 12V TRIGGER ZONE 2 terminal
When the TX-DS797 is in the ZONE 2 mode, this terminal outputs at
12 V/100 mA.
13