Enjoying Music In The Remote Zone; Playing Music Using The Buttons; Selecting An Input Source Using; On The Tx=Ds797 - Onkyo TX-DS797 Instruction Manual

Enjoying music in the remote zone
ZONE 2 indicator ZONE 2 OFF
I 1 ......... ............
t__J t__J
input source buttons
ON/STDBY
buttons
ZONE 2
I Playing music the buttons the TX-DS797 /
]
using on
1. Press the Zone 2 button on the TX-DS797.
2. Select a source.
After pressing the Zone 2 button, you must press an input source
button within 5 seconds. The Zone 2 indicator lights.
Ex.: When the CD button is pressed.
I
=8--::-
To select the same source for the remote zone that is selected
for the main zone, press the Zone 2 button again until
"Zone2SehSOURCE" appears in the display.
l ,._: ....-- .: _ ...-..-... ::-..-.:...
",:5. 0 i'3 e.eS--, _' i ;; ".', Li Li i"O.., t::.
When "Zone2Sel:Off" is displayed, the output to the remote
zone is turned oft'.
Notes:
• If a sleep time is set with the SLEEP button, it will also work for
the remote zone.
• If the source for the main zone is selected as the source for the
remote zone and the source for the main zone is changed, then
the source for the remote zone will change as well.
• The Zone 2 terminal is an analog oulput. Digital signals are not
output. If no sound is heard from the selected input source, check
if the component is connected to the analog inputs.
• If the REC OUT button is pressed in the main room while
someone is using the system in the remole zone, the Zone 2
function will be deactivated and the source will turn off in the
remote zone.
• If you select FM (or AM) with the input source bultons when the
source for the remote zone (Zone 2) is set to AM (or FM), the
output for the remote zone also changes to AM (or FM).
• When you are using the remote zone (Zone 2), RI system
operation will not work.
• When you are not using the remole zone (Zone 2), press the
ZONE 2 button and then press the OFF button to turn off the
ZONE 2 indicator.
Selecting an input source using the remote
controller
Turning on the Zone 2 and putting it in the standby state
when the TX-DS797 is in the standby state:
After pressing the ZONE 2 button, press the ON/STDBY button
within 5 seconds.
s_ac, 0_
Selecting an input source:
After pressing the ZONE 2 button, press an input source button
within 5 seconds.
If tuner is selected with the TUN button, the CH ÷/= button becomes
enabled.
SEARCH
Notes:
• Adjust the volume for the remote zone at the pre=main amplifier.
• After you press the ZONE 2 button on the remote controller, the
STANDBY indicator on the TX-DS797 flashes for five seconds.
During this time, you will not be able to perform operations in
the main zone using the remote controller.
54