Continuing The Program When The Rinse Is Stopped; Removing Laundry; Switching Off The Device; Parental Control - Bosch WAN282E4FG Instructions For Use And Assembly

deParental controls
– If the water level is high, start the
programCentrifuge / Essorageor
set a suitable program for
pumping.
→ "Programs", page 24
Remove the laundry.
3.
→ ""Removing laundry", page 32
13.13 Continue program
when rinsing stops
requirements
¡The rinse stop is activated.
→
"Buttons", page 23
¡The last rinse cycle of the set
The th program has ended and
the laundry is in the rinse water.
The programCentrifuge /
1.
Essorageor set a pumping
program.
→ "Programs", page 24
OnStart/Bijvullen / Départ/Rajout
2.
press.
13.14 Remove laundry
Open the door.
1.
Take the laundry out of the drum.
2.
13.15 Switch off device
Open the program selectorUit /
1.
Arrêtplace.
Close the tap.
2.
32
Wipe the rubber sleeve dry and
3.
remove foreign objects.
Leave the appliance door and
4.
detergent drawer open so that any
remaining water can dry off.
14 Parental Controls
Secure your device against
accidental operation of the controls.

14.1 Activate parental controls

Press both buttons
▶
for seconds.
aThe display shows
aThe controls are locked. aThe
parental controls also remain
active after switching off the device and in
the event of a power failure.
14.2 Deactivate parental

controls

Requirement:To deactivate parental
controls, the device must be switched
on.
Press both buttons
▶
for seconds.
aThe display goes out
3 sec.approx. 3
.
3 sec.approx. 3
.