Table of Contents
Advertisement
enservice
13.10 Soaking laundry
A notice:No additional detergent is
necessary. The suds are then used
for washing.
Start the program.
1.
To pause the program, open after
2.
about 10 minutesStart/ Reloadto
press.
To continue the program, after the
3.
desired soaking timeStart/Reloadto
press.
13.11 Add laundry
onStart/Reloadto press. The
1.
device pauses.
A notice:if
It is not possible to add laundry.
When goes out, it is possible to add
laundry.
Open the appliance door.
2.
Add or remove the laundry.
3.
Close the appliance door.
4.
onStart/Reloadto press.
5.
13.12 Cancel program
onStart/Reload
1.
Open the appliance door.
2.
When the temperature and water
level are high, the door will remain
locked for safety reasons.
– If the temperature is high, start
the programWash .
– If the water level is high, start the
programSling or select a suitable
pumping program.
→ "programs", page 24
Take out the laundry
3.
→ page 32 .
32
appears is
to press.
men
13.13 Continue program at
rinse stop
requirements
¡The rinse hold is activated.
→
"Buttons", page 23
¡The last rinse of the set
th program is finished and the
laundry is in the rinse water.
The programSlingor set a program
1.
for draining.
→ "programs", page 24
onStart/Reloadto press.
2.
13.14 Remove laundry
Open the appliance door.
1.
Remove the laundry.
2.
13.15 Switch off the device
Open the program selectorOut of
1.
place.
Turn off the tap.
2.
Wipe the rubber boot dry and
3.
remove foreign objects.
Leave the appliance door and the
4.
detergent drawer open so that any
residual water can dry off.
Advertisement
Table of Contents
