Table of Contents
Advertisement
2 Avoid material damage
the
DANGER!
Incorrect dosing of fabric softeners,
detergents, care products and
cleaning agents can impair the
function of the device.
▶
Follow the manufacturer's dosage
recommendations.
Exceeding the maximum load
capacity will affect the device
function.
Observe the maximum load capacity
▶
for each program and do not
exceed it.
→ "Programs", page 24
The device is secured for transport
with transport locks. Transport locks
that are not removed can lead to
property damage and damage to the
device.
Before commissioning, completely
▶
remove and store all transport
locks.
Completely install all transport
▶
locks before each transport to
avoid transport damage.
Improper connection of the water
inlet hose can result in property
damage.
▶ Tighten the screw connections on the
water inlet hand-tight.
Connect the water inlet hose
▶
directly to the tap without
additional connecting elements
such as adapters, extensions or
valves.
Make sure that the inside
▶
diameter of the tap is at least 17
mm.
Make sure that the length of the
▶
thread at the connection to the tap
is at least 10 mm.
Avoid property damagede
If the water pressure is too low or too
high, the device function can be
impaired.
Ensure that the water pressure at
▶
the water supply system is at least
100 kPa (1 bar) and maximum 1000
kPa (10 bar).
If the water pressure exceeds the
▶
specified maximum value, a
pressure reducing valve must be
installed between the drinking
water connection and the hose set
of the device.
Do not connect the device to the
▶
mixer tap of a non-pressurized hot
water heater.
Modified or damaged water hoses
can lead to property damage and
equipment damage.
Never bend, squeeze, alter or cut
▶
water hoses.
Only use the water hoses supplied
▶
or original replacement hoses.
Never reuse used water hoses.
▶
Operating with dirty water or water
that is too hot can lead to property
damage and equipment damage.
Operate the device exclusively
▶
with cold tap water. Unsuitable
cleaning agents can damage the
surfaces of the device.
Do not use harsh or abrasive
▶
cleaning agents.
▶
Do not use cleaning agents that
contain strong alcohol content.
Do not use hard scouring pads or
▶
cleaning sponges.
Clean the device only with water
▶
and a soft, damp cloth.
▶
If you come into contact with the device,
immediately remove any detergent
residue, spray mist or residue.
11
Advertisement
Table of Contents
