Disturbance
Door cannot be
opened.
There will be no detergent
pumped out.
Cause and troubleshooting
Cancel program.
▶
→ "Cancel program", page 31
Water level is too high.
Choose a suitable pumping program.
▶
→ "Programs", page 24
Power failure.
Open the door with the emergency release.
▶
→
"Emergency release", page 49
Drain pipe or water drain hose is blocked.
Clean the drain pipe and water drain hose.
▶
Drain pipe or water drain hose is kinked or pinched.
Make sure the drain pipe and water drain hose are
▶
not kinked or pinched.
Drain pump is clogged.
→
"Cleaning the drain pump", page 35
▶
- - - is activated.
Continue the program byCentrifuge / Essorageor
▶
Afpompen / Vidangechoose andStart/Bijvullen /
Départ/Rajoutpress.
→
""Continue program when rinsing is stopped", page 32
Water drain hose is connected too high.
Mount the water drain hose at a maximum height
▶
of 1 meter.
Pump cover is not assembled correctly.
Assemble the pump cover correctly.
▶
Detergent dosage is too high.
Immediate measure: Mix a tablespoon of fabric
▶
softener with 0.5 liters of water and fill the mixture
into chamber II (not for outdoor, sportswear and
down textiles).
The next time you wash the same load, reduce the
▶
amount of detergent.
Unauthorized extension installed on the water drain
hose.
Remove any unauthorized extensions from the water
▶
drain hose.
→
"Connecting the device", page 15
Troubleshootingde
43