Canon ELURA 50 Instruction Manual page 98

When you play back a tape that was recorded in 12_bit mode, you can set die
audio output to play: stereo 1 0be original sound), stereo 2 (any new sound,
dubbed to the tape after recording), or mix die balance between the two.
• Audio from the 16_bit mode only contains stereo 1 sound and so you cannot!do
not need to select the audio mix. The same is _rue for die 12_bit stereo 1 mode,
unless new sound has been added post-recording.
c
"D
I11
1. Choose the output.
• Press AUDIO MONITOR on the wireless controller.
• Starting with the last selected setting, 4 settings appear as you push the
button:
-STEREO1 for just stereo I.
- STEREO2 for just stereo 2.
- MIX/FIXED for an equal mix of stereo I and 2.
- MIX/VARI, (mix variable) for when you want to mix the balance between
stereo I and 2.
• "[b simply choose STEREO1, STEREO2 or MIX/FIXED, make sure your
choice appears on the display.
• If you choose MIX/VARI., you can go on to mix die balance.
• Use die STylISTs2 keys to mix the balance. A bar showing the mix appears
on the screen for 4 seconds.
[] Note:
• When you have chosen the output, STEREOI, STEREO2, MIX/FIXED or
MIX/VARI. is shown in tbe top left of the display for a few seconds. If you turn
the power off, the output is set to STEREO1.
98