Canon ELURA 50 Instruction Manual page 136

4. Select MIX TYPE.
• CARD CHROMA, CARD LUMI., CAM. CHROMA settings appeal-.
5. Select the desired setting.
• Your currently recording image is combined with tile pre_recorded still
image.
6. Select MIX LEVEL and press the SET button.
7. Adjust the mix level.
• Turning the selector dial upwards adjusts to the right and turning
downwards adjusts to the left.
8. Close the menu.
• CARD MIX flashes in the display.
9. Press the CARD MIX button.
• CARD MIX stops flashing.
• Your currently recording image is combined with tile pre-recorded still
image.
• Each time you press tile card MIX button, your selection is activated
(display lights continuously) or deactivated (display flashes).
For movies 1
1. Press the start/stop button to start and stop recording.
• The combined images are recorded onto the tape.
For stills 1
1. Press the PHOTO button halfway down and hold it.
• O flashes white in the display as the camcorder adjusts the focus and it is
displayed continuously as a green mark when the camcorder is ready to take
the image.
t_ 2. Press the PHOTO button fully down to record the image onto the
_, tape.
o • O disappears from the display.
E
_a • The combined images are recorded onto the tape for approximately 6
seconds.
[] Notes:
:_ • If you change the position of the POWER switch, select your still flnage for
Card Mix again.
• When setting Card Mix, you must carry out steps I to 5.
136