Canon ELURA 50 Instruction Manual page 147

i!ii
Press the small hole with a pen and pull out
the battery holden Insert the battery into The
battery holder so tbat the + side of the battery
faces the + sign on tbe battery holder. Insert
the battery holder back into place.
This backup battery allows the camcorder to
remember the date and time and other settings
when main power source is removed. It has a
life span of about a year.
When it needs replacing (or if it has not been
installed), the _ mark flashes in the display.
Remove the old battery by pushing up then releasing and lifting out. Make sure to
attach a power source to the camcorder first, so it will remember your chosen
settings when you change the battery.
-O-
DANGER!
Treat the battery pack with care.
• Keep it away from fire (or it might explode).
• Do not expose the battery pack to temperatores greater than 14fl°F (60°C).
Do not leave it near a heater, or inside a car in hot weather, for example.
• Do not try to disassemble or modil}¢ it.
• Do not drop or knock it.
• Do not get it wet.
WARNING!
• The battery used in this device may present a fire or chemical burn hazard if
mistreated. Do not recharge, disassemble, heat above 212°F (100°C) or
incinerate.
• Replace tbe battery with a CR1616 made by one of the lollowing companies:
Panasonic, Hitachi Maxell, Sony, Toshiba, Varta, Renata. Use of other
batteries may present a risk of fire or explosion.
Cautions:
• Do not pick up tbe battery using tweezers or other metal tools -- this will cause
a short circuit.
• Wipe the battery with a clean, dry cloth to ensure proper contact.
• Keep the battery pack out of reach of children -- if it is swallowed, contact a
physician immediately, as the battery case may break down and the battery
fluids damage tile stomach and intestines.
• Do not disassemble, heat or immerse the battery in water, to avoid tile risk of
explosion.
5"1_,
147